Back to top

1980 Jupiter 30

United Kingdom

€15,016

Designed by Van de Stadt this Jupiter 30 was built around 1980. Competitive cruiser/racer with a good performance that offers also a comfortable interior for family cruising.
Yes - she is not in her first flush of youth but she has been regularly maintained by her current owner and now represents an opportunity for a new owner!  She has also had some upgrades since the photos were taken - including new upholstery...

Basic Boat Info

Tax Status: Paid
Make: Jupiter
Model: 30
Year: 1980
Condition: Used
Category: Sail
Builder: Jupiter
Construction: Fiberglass
Keel Type: Fin Keel

Dimensions

Length: 29'5 ft / 8.96 m
Length Overall: 30 ft / 9.14 m
Beam: 10'5 ft / 3.17 m
Max Draft: 5'1 ft / 1.55 m
Displacement: 3,400 kg
Electrical Circuit: 12 V
Single Berths: 1
Double Berths: 1
Twin Berths: 1
Cabins Count: 2

Engines / Speed

Engines: 1
  • Make: Yanmar
  • Model: YSE
  • Drive Type: Direct
  • Fuel: Diesel
  • Engine Power: 12hp
  • Type: Inboard
  • Propeller Type: 2 Blade, Folding

Tanks

Fuel Tanks: 1
Fuel Tank Capacity: 50 L
Water Tanks: 1
Water Tank Capacity: 100 L

Other

Heads Count: 1
Drive Type: Direct
Boat Class: Cruisers, Racers and Cruisers

Contact

John Harkness
BJ Marine

Office

BJ Marine (Bangor)
Bangor Marina Bangor
Co. Down, Northern Ireland, GB, BT20 5ED
Tel:+44 (0)7564 366639


Construction

GRP with gel coat finish - blue hull and white deck. Fin keel.
Self draining cockpit
Interior joinery in teak and mahogany
Trim on deck in teak
Rudder bearings were replaced in 2017

Mahogany rubbing strake replace 2018

Dimensions and Tankage

Length Overall: 8.96m / 29'4"
Length at Waterline: 7.53m / 24'8"
Beam: 3.17m / 10'4"
Max Draft: 1.55m / 5'1"
Displacement: 4394kg


Tankage -
Fuel: 50l
Water: 100l (flexible tank)

Engine

Yanmar YSE 12hp - with a reputation for economy of operation.
Stern gland and exhaust elbow both replace in 2015

Prop: 2-blade folding in bronze

Engine last serviced - summer 2018 and is due to be serviced again in summer 2019

Rudder bearings were changed in 2018

 

Accommodation

The saloon is offset to port with a linear galley and nav station to startboard. There is a large aft/quarter berth to starboard aft of the nav station.
The saloon seating (seats 5-6) also converts for use as a double berth. Heads is by the companionway on the starboard side and a good size.
The forecabin has a closing sliding door, and has 2 large single berths with insert conversion to large double berth with large hanging lockers on either side.
Good stowage beneath the v-berth.
Galley has a gimballed 2 burner gas cooker with oven and grill. There is also a microwave oven - Russell Hobbs. Good storage.
Stainless steel sink. Water system is cold water and manual. Currently no fridge/coolbox.
Chart table with map reading light and chart storage
3 large dry food storage lockers under seating in moulded white GRP
Double skin insulation throughout and Eberspacher heating.
Ventilation port in main cabin, forward cabin and heads

Upholstery replaced 2017 now white - and brings in a lot more light.

Sails and Rig

Masthead sloop with slab reefing main with lazy lines and stack pack - all new in 2016 by Sketrick.
Furling genoa with facnor SD150 furling system. UV strip replaced 2015.
There is also a 2nd genoa and a cruising chute.
Black Aluminium mast and boom with stainless steel standing rigging. Backstay tensioner.
Spinnaker boom.

Last change of standing rigger - not known

Additional Contact Information

Contact John now  - on +44(0)7564 366 639